Clutch assymbly

Begonnen von opus, 20 Mai 2006, 19:46:48

« vorheriges - nächstes »

0 Mitglieder und 1 Gast betrachten dieses Thema.

opus

Hello

I am trying to put together my clutch.The bike is a BMW R 25/3.  What must I do
?

opus


Dave

Allo Opus,

A good start would be the R26 manual here at Einzylinder (Start > Tips > Handbuecher >  INSTANDSETZUNGSANLEITUNG R26 & R27Deutsch / English / Italiano / Francais [13 Mb]).

I **THINK** the clutches are same / similar and this manual is well illustrated.

Dave.

Jesper Mikkelsen

Hello.

I have not parted the clutch. I have just taken the rear part off,and now it will not fit together. Must the clutch plates be tigthend or ?

Jesper

Garnet Grylls

Jesper

You will need to use 3 long blots with a nut on them to start to pull the clutch together before the stock bolts will start.

Run the nuts all the way up the long bolts and thread them in by hand into every other hole. Tighten the nuts down one turn at a time till the friction plate is compressed enough to start the short bolts that held the clutch together originaly. Then remove the long bolts and replace with the last 3 short bolts and tighten them all down evenly.

Garnet

Similar topics (5)

Hauptmenü

Anleitungen & Bücher Baureihe Specials Startseite Vergleichsliste

Presse & Wissen

Bauzeiten & Stückzahlen Historisches Liste der BMW Modelle Presseberichte Prospekte & Plakate

Foren & Literatur

Bildergalerie Bildtafel-Suche Forum: Boxerforum Handbücher Servicedaten

Allgemeine Infos

Bildtafelsuche Glossar Impressum Kontakt Sitemap

Tipps & Service

Dienstleister Händler Märkte & Museen Tipps Verschleißteile & Werkzeuge