R26 Engine Stand for Repair Work

Begonnen von Carott, 15 März 2021, 23:13:12

« vorheriges - nächstes »

0 Mitglieder und 1 Gast betrachten dieses Thema.

Carott

I remember seeing a dimensioned drawing to cut a steel plate for attaching to the R26 engine for benchtop repair work.
After several search attempts I have not found it and would appreciate any help to point me in the correct direction.
Thank you in advance,

Brett

Carott



Taz

Hello Brett.

You may have been searching for this page: https://cms.bmw-einzylinder.de/index.php/literatur/werkzeugbauanleitungen-und-skizzen.html

The specific tool you remember is called "V5017 - Aufnahme f. Getriebe - R24 / 25 / 51", also to be found on that page.

If you would need DXF-files to have it laser-cut at a shop close to you please send me a PM with your email address, I will send them to you then (had a number of these tools made in late 2019).

Kind regards, Taz
Ich hab noch nie einen Sarkasmus vorgetäuscht


auf Tour:

Zipfelreise (2019)
Cymru "Radnor Revivals" (2016)
Alba "Isle of Skye" (2013)
Austria Großglocknerhochalpenstrasse (2012)
Alba "Spittal of Glenshee" (2011)

Carott

Thank you Taz, that was just what I needed.
I will attempt to build my own stand but if it get too frustrated I will contact you for the dxf. file.

Stay well,

Brett

Similar topics (5)

Hauptmenü

Anleitungen & Bücher Baureihe Specials Startseite Vergleichsliste

Presse & Wissen

Bauzeiten & Stückzahlen Historisches Liste der BMW Modelle Presseberichte Prospekte & Plakate

Foren & Literatur

Bildergalerie Bildtafel-Suche Forum: Boxerforum Handbücher Servicedaten

Allgemeine Infos

Bildtafelsuche Glossar Impressum Kontakt Sitemap

Tipps & Service

Dienstleister Händler Märkte & Museen Tipps Verschleißteile & Werkzeuge